?? About tag corner punch

[overcome]

I just noticed the new tag corner punch. Do you think this would enable you to layer tags? Say you punched this on a 1 x 3 rectangle...if you used it on a 1 1/2 x 3 1/2 rectangle, would you be able to layer them? I can't wrap my brain around this to figure out if it would be proportional.

TIA

Ashley

[craftymel]

Good question, I'm interested in learning the answer to this as well.
Melanie

[rhondag]

I just did it with two post its and some scissors. (I cut the rectangle slightly smaller as if I were going to mat one on the other. Then, I cut both pieces at the same time so the amount and angle would be the same.) It worked.

[Alle Rednic]

Will it let you layer with the tag puch tag? It looks to me like the angle is the same...but can't tell...
Patti