Slot punch that makes half-circles?

[awain]

Does anyone know which punch is used to make the half-circle slots that can hold little cards? I have a corner circle slot punch but it only works on corners.

[Shanon]

SU sells a "slit" punch that I use quite a bit!!

[CrabbyAbbe]

I believe that would be the slit punch. On page 222 in the catty.

[jcbmri]

If you have the CM Custom Cutting System, you could use the small circle with the red cutter. Hope this helps! Joyce

[yvonne62]

I use the smallest circle from the Coluzzle system for that and just cut a half circle. Works well!

[awain]

Thanks for all the great suggestions! They all beat winging it with an Exacto blade - I never could get the hang of those!

[Steffani]

Did you every try to see if the corner guide pops out. It does on the wrought iron punch and then you can go straight on the paper. It pops back in to do corners. That way you don't need two punches.

Steffani

[pixiepinkgirl]

Thanks Steffani! for the great suggestion to remove that guide. Never thought to do that. Must try that